Hong Kong Bearing Group Limited

Influence Of Fatigue Pitting On Precision Bearing Troubleshooting

Apr 20, 2023

When the rolling body is under load, the contact surface of the rolling body and the inner and outer ring will produce contact stress, and the inner and outer ring and the rolling body have relative rotating motion in the work, so the contact stress will change. When the contact stress exceeds the specified value, the fatigue crack occurs under the surface and gradually expands to the surface, causing fatigue pitting on the surface of the rolling body of the inner and outer ring. It leads to the loss of rotating accuracy, noise, impact and vibration of precision bearings, so pitting is the fault form of rolling precision bearings. Then, the following is to understand the influence of fatigue pitting on the troubleshooting of precision bearings.
Methods to increase the service life of precision bearings:
The life of precision bearings is closely related to production, manufacturing, installation and application, so that the precision bearings can reach the running condition and increase the service life of precision bearings if they are done well in each stage.
1. Selection and operation of dimensional tolerance of shaft and bearing chamber: bearing pressed into bearing should be able to rotate easily without sliding block. When it is obviously inconvenient to rotate, the size of the shaft is too large, please reduce the size tolerance. After precision bearings are pressed into the shaft, if there is an obvious sense of "loosening" in the rotation they are good at, the dimensional tolerance of the shaft may be large, or the concentricity of the shaft may not be good. Therefore, in the control of dimensional tolerance of precision bearings and precision bearing chambers, do a good job of concentricity. At this stage, many Chinese manufacturers can only operate dimensional tolerance, without concentricity.
2. Installation method: Because precision bearings are high-precision commodities, poor installation is easy to damage the cross section of precision bearings, thus damaging bearings. The installation of precision bearings requires special types of shells, which can not be knocked casually. When you press the shaft, you apply force only to the circle. When you press the great circle, you apply force only to the great circle. When installing standard air pressure or hydraulic press, when riveting horizontally from left to right, if deflection occurs, the cross section of the bearing will be damaged by the precision bearing, and the wire of the precision bearing will be damaged.
3. Avoid dirt will: when the bearing is placed on the motor rotor to achieve the dynamic balance of the rotor, the iron pin generated by the dynamic balance of the rotor is easy to be placed into the precision bearing, so before installing the bearing, the rotor can maintain a good dynamic balance. In order to facilitate installation, some manufacturers install oil or vegetable oil in the bearing room to wet the actual effect, but the actual operator is difficult to control the amount of oil or vegetable oil in the precision bearing room, if there is a lot of oil or vegetable oil in the room, the rotation of the bearing will follow the shaft and adhere to the precision bearing room do not apply oil or vegetable oil. When applicable, do not store in the precision bearing chamber during operation.
4, paint rust prevention: paint rust is characterized by multiple closed motor, motor installation sound is very good, but after placed in the warehouse for a period of time, precision bearing motor sound becomes very loud, disassembled bearing has more serious rust situation. Many manufacturers used to think it was precision bearings.

goTop